Fixing Guide for AAC Blockwalls
Please refer below for table of type of fixings and their loading capacity respectively.
请参阅以下的类型表,说明固定装置和承受能力的区别.
LIGHT DUTY 轻型 | |||
Applications :
Range of Approx. Weight (可承受量) : |
|||
Fixing type | Bolt Diameter ( mm ) |
Recomnd Load Per Fixing ( kg ) |
Ultimate Load Per Fixing ( kg ) |
6 | 3 | 15 | |
8 | 10 | 50 |
MEDIUM DUTY 中型 | |||
Applications :
Range of Approx. Weight (可承受量) : |
|||
Fixing type | Bolt Diameter ( mm ) |
Recomnd Load Per Fixing ( kg ) |
Ultimate Load Per Fixing ( kg ) |
10 | 20 | 100 | |
8 | 30 | 150 |
HEAVY DUTY 轻型 | |||
Applications :
Range of Approx. Weight (可承受量) : |
|||
Fixing type | Bolt Diameter ( mm ) |
Recomnd Load Per Fixing ( kg ) |
Ultimate Load Per Fixing ( kg ) |
8 | 50 | 280* | |
NOTES :
- All samples are tested on Greencon AAC Blocks ( 600L x 200H x 100W )
- All Installation of anchors are in accordance to products’ instruction.
- Recommended load computed by applying safety factor of 5 on the Ultimate Load. It is advicable not to exceed the Recommended Load for on-site applications.
- Drill holes for fixing advice be drilled with standard high speed steel bit without hammer action.
- Drilled holes must be thoroughly cleaned with standard cleaning kit.
- Nail may be used on Greencon AAC Blocks for light duty works such as fixing of hangers and light picture frames. However, Statheros anchors are more durable and safe in long term.
- Suitability of anchors into Greencon AAC Blocks is not limited to the above range. Please contact Supplier for more details.
- Values shown in these tables are based on testing conducted by RFM Construction Products ( M ) Sdn Bhd.
* Test conducted after 15 minutes of installation
* Test AAC Block ( 600L x 200H x 100W ) cracked.
Fixing Steel "L" Bracket Using RamsetTM TrakMaster With RamsetTM Drive Pins.
The steel "L" Bracket is
for block work tie back to column.
RFM Construction Products ( M ) Sdn Bhd
( Co. No. 926228-U )
No.67 (1st Floor), Jalan Nllam 1/2,
Subang Hl-Tech Industrial Park,
40000 Shah Alam, Selangor Darul Ehsan,
Malaysia.
Tel : (603) 5632 8186
Fax : (603) 5635 1186
E-mail : Info@rfmcp.com
Website : www.rfmcp.com
Johor Branch
No.63, Jalan Ros Merah 3/1,
Taman Johor Jaya,
81100 Johor Bahru,
Malaysia.
Tel : (607) 351 9414
Fax : (607) 351 9254
Penang Branch
No.23, Tingkat Bawah, Lorong Kelasah 2,
Taman Kelasah, 13700 Seberang Jaya,
Peral, Penang,
Malaysia.
Tel : (604) 399 3372
Fax : (604) 398 3372
The information presented herein is supplied in good faith and to the best of our knowledge was accurate at the time of preparation. No responsibility can be accepted by RFM Construction Products ( M ) Sdn Bhd or Its staff for any errors or omissions. The provision of this Information should not be construed as a recommendation to use any products in of any patent rights or in breach of any statute or regulation. User are advised to make their own determination as to the suitability of this Information in relation to their particular purpose and specific circumstances. Since the Information contained in this document may be applied under conditions beyond our control, no responsibility can be accepted by us for any loss or damage caused by any person acting or refraining from action as a result of this information.